China Plastic Recycling Processing Water Suppliers | Quality Factory Solutions for Waste Plastic Management
Wastewater Quality
| Industry | Special ceramics | |||
|---|---|---|---|---|
| Parameter | Unit | Inlet | Outlet | Remark |
| Flow | m³/h(d) | 40 | / | / |
| pH | / | 7~8 | 7~8 | / |
| Suspended solids | mg/l | 2000 | 200 | / |
|
Heavy Metal Cr/Cu/Ni/Zn/Fe... |
mg/l | / | / | / |
| Other | / | / | / | / |
| Moisture content of mud cake | % | ≤30 | / | |
Frequently Asked Questions
What is the typical flow rate of wastewater in special ceramics manufacturing?
The typical design inlet wastewater flow rate for the special ceramics industry in this setup is 40 m³/h(d).
What is the expected pH level of the inlet and outlet wastewater?
Both the inlet and outlet wastewater maintain a stable and neutral pH range of 7 to 8, which is optimal for standard discharge and treatment processes.
How effectively are suspended solids (SS) reduced in this process?
The treatment process significantly reduces suspended solids (SS) from an inlet concentration of 2000 mg/l down to an outlet concentration of 200 mg/l.
Are there specific limits for heavy metals in special ceramics wastewater?
Heavy metals such as Chromium (Cr), Copper (Cu), Nickel (Ni), Zinc (Zn), and Iron (Fe) are monitored as required. Specific inlet and outlet parameters are determined based on raw materials and local regulatory standards.
What is the target moisture content of the treated mud cake?
Following dewatering and filtration, the moisture content of the resulting mud cake is managed to remain at or below 30% (≤30%).